Juniper JN0-662 Exam Dumps

Choose Passcert Juniper JN 0 662 Exam Dumps ensure you pass the exam at your first try. Juniper JN 0 662 Exam Dumps are the completely real original braindumps. It is finished and summarized by our professional team, and corrected by seniors. JN0-662 Exam Dumps before you participate the certification exam.

100% pass Juniper JN0-662 Exam with Passcert valid JN0-662 dumps

Share some JNCIP-SP JN 0-662 exam questions and answers below.

Which two types of LSAs have a domain scope? (Choose two.)

A. Type 7

B. Type 2

C. Type 10

D. Type 5

Answer: C, D

Which transport mechanism is required for Layer 3 VPNs?

A. GRE

B. VXLAN

C. IPsec

D. MPLS

Answer: D

You want to use IS-IS on a GRE interface where the underlying Layer 3 MTU is 1500.

Which statement is correct in this scenario?

A. IS-IS can be used because every IS-IS interface must be capable of transmitting packets at least as large as 1476 bytes, and the GRE header is 24 bytes.

B. IS IS can be used, but the networking device is directly attached to the circuit must be capable of fragmentation.

C. IS-IS can not be used, but the router can enable GRE key that serves the same function as IS-IS.

D. IS-IS can not be used because the IS-IS hello is not allowed to be fragmented and has the DF bit set.

Answer: B

Which statement is correct regarding BGP route reflectors?

A. The route reflectors must have a private AS number.

B. The route reflectors must have an EBGP peering session between each other.

C. The route reflectors must have a cluster ID configured.

D. The route reflectors must have a different AS number than the clients.

Answer: C

Your implementation must allow for load sharing between redundant RPs and should an RP failure occur, the RP failover time should be minimized.

Which two configuration tasks are required in this scenario? (Choose two.)

A. Configure MSDP peering sessions between the routers designated as RPs.

B. Configure the shared anycast address on the RPs as the primary address on the loopback interface.

C. On the routers designated as RPs, configure the shared anycast address on the loopback interface.

D. Configure at least two static RPs and bundle them in an RP redundancy group under [edit protocols pim].

Answer: B, D

How to Pass Juniper JN0-662 exam easily?-Passcert JNCIP-SP JN0-662 dumps

JN 0-662 exam. JN 0-662 Exam Dumps about Juniper certification JN 0-662 exam on Passcert as a exam, so that you you Generally, if you have tried Passcert products, you'll very confident of our products.

Free Download JNCIP-SP JN 0-662 dumps, 100% Pass In Your First Attempt.

It is generally for the reason that it is for the reason for being who will be who will help the standing with its providers by just inventing a new challenge When preparing Juniper JN 0-662 exam, you can choose Passcert Juniper JN 0-662 Exam Dumps for the Juniper certification.

Save 27% discount in Passcert 12th Anniversary

When you choose to participate in the Juniper JN 0-662 exam, it is necessary to pass it. If you are concerned about the test, you can choose Passcert's And you can pass the exam successfully. Juniper JN0-662 Exam Dumps. No matter how low your qualifications, you can easily understand the content of the Juniper